With the continuous development of the society, the use of fully automatic vacuum packaging machines has basically run through all industries. From clothing, food and shelter to the development of industry and peasant industry, it has begun to inseparable from its appearance, but as long as it is a machine, various problems will arise. So today I will analyze with you the common problems of the automatic vacuum packaging machine and the solutions.

First, the vacuum is not enough or no vacuum:

First, it may be that the bag is leaking and needs to be replaced with a new one.

Second, there may be no vacuum in the heat-sealed air chamber when vacuum is required, and the maintenance should be eliminated.

Third, it is also possible that the seal on the 1DT core seal or the magnetic cover leaks, which can only be repaired or replaced.

Second, the vacuum packaging opportunity appears insufficient sealing strength:

First, let's see if the temperature time adjustment is too low or too short. If it is, then re-adjust.

Second, is the vacuum time adjustment too short, the solution is to adjust it to be less than or equal to -0.08Mpa;

If neither of the above is true, then it is necessary to see if the heat-sealed air chamber is broken. If this is the case, then it will be replaced.

Third, the seal is not flat or dissolved:

This is mainly due to temperature time problems, the solution is to re-adjust; or 2sj does not work, the solution is to re-adjust, repair or replace; if the heat seal delay is found to be too long, the power should be cut off in time.

For fully automatic vacuum packaging machines, maintenance is important.